How to remove the body of Automower® 305, 310 Mark II, 315 Mark II, 405X and 415X

Follow these steps to remove the top cover and body of Husqvarna Automower® 305 (2020-), 310 Mark II, 315 Mark II, 405X and 415X, for example if your robotic lawn mower requires thorough cleaning.

Clean off dirt and grass

Before you start disassembling your robotic lawn mower, ensure that all dirt and grass clippings are cleaned off the product.

Remove the top cover

1. Turn off the product.
2. Carefully pull the top cover at the rear, the front and the middle.
3. Lift up the top cover to remove it.
   
   

Remove the body

1. Locate the maintenance tool, which is attached over one of the rear wheels.
2. Locate the four positions where the body is attached.
3. Push the maintenance tool down in one of the four positions, and pull the body up.
4. Continue pushing the tool down in the remaining positions while you hold the body up.
   
   
5. Carefully lift the body at the rear and fold it over to remove it. Do not remove the charging cable.
   
   

Reinstall the body and top cover

1. Put the body on the chassis and push it into position.
2. Attach the maintenance tool in its position over one of the rear wheels.
3. Put the top cover on the body of the product and push it into position.
4. Ensure that the grommets for the charging cable are correctly installed to provide a seal against moisture.

Click here to find out how to clean your Automower® robotic lawn mower.

For personalised assistance with your Automower® robotic lawn mower, please contact your local Husqvarna dealer.